Re: Jeff's interface

It is indeed just a 'levelconverter'. So the serial port has to be
set to the desired baudrate. And it is no problem, to set the serial
port to e.g. 10.4 KBaud, at least not if you are writing your own
software :).

Sander.

--- In opendiag@yahoogroups.com, "John Page" <John.page@e...> wrote:
> Please excuse me, as a newcomer to this group I see references to
> Jeff's interface. Looking at the schematic, it converts between the
> electrical standards but there is no baud-rate change component, so
> if the laptop is set to 9600 baud then so is the OBD interface.
>
> Am I correct in assuming that this circuit cannot connect to a 10.4
> KBaud ISO interface - only at the same speed as the RS232 port is
set
> to?
>
> Thanks,
> John

 
Received on Mon Nov 10 00:03:29 2003