benjamin@... wrote:
>
> Can you tell use some more about the "intelligent"
> interface
http://www.softing.de/e/PRODUCTS/AUTOMOTIVE_ELECTRONICS/products/interfaces/interfaces.html
> and the dump [dumb] interface....
Like you would find on Jeff's page.
> My VW-Dealer runs his Diagnostic software on a win9x pc....
What diagnostic software is he using?
> Does uploading software use any other pins on the ODB-II
> connector besides K-Line?
I don't think so.
> On my new Golf IV TDI are some more pins on the connector
> hooked up..
Pins 6 and 13? Powertrain CAN.
> On an older Golf iV (my parent's one) are only 3 pins hooked
> up I think gnd vcc k-line... I don't know it that doesn't
> support flash-upgrading...
Probably because it has two PLCC chips (not FLASH) (if it is a TDI).
> With the German Diag-Software it should be entirely possible to
> even figure out how the "intelligent" interface works...
It doesn't matter how it works, I just want to see the data going back
and forth between it and the car when the FLASH is being uploaded or
downloaded..:-)
-Uwe- http://www.Ross-Tech.com
Received on Sun Apr 01 12:29:01 2001
This archive was generated by hypermail 2.1.8 : Wed Jan 02 2008 - 00:56:01 CET