Re: [opendiag] Vectra transmission ECU pin-out needed

Hi all,

Thanks for the reply Bora. Unfortunately, it appears I have a different connector to the pin-outs provided. The Gearbox ECU I have uses a 42-pin plug. I managed to get this ECU up-and-running using the following pin-out:

Pin 11 = Diagnostic line
Pin 20 = Battery +ve
Pin 21 = Ignition ON
Pins 41 and 42 = Ground

Best regards,

Grant.

----- Original Message -----
From: BORA
To: opendiag@yahoogroups.com
Sent: Wednesday, December 20, 2006 10:18 PM
Subject: Re: [opendiag] Vectra transmission ECU pin-out needed

pin 16 permanent +
pin 1 ignition +
pin 31 and 32 is the GND
pin 21 is the DIAG link

4AT from X20XEV / 1998
don't know what manufacturer is the module but I
suppose is what you need

BORA

--- gneobd <gnorman@...> wrote:
> Hi all,
> Does anyone have connector pin-out information for
> the following
> Opel/Vauxhall Transmission ECU:
> Aisin AW Co. Ltd (Japan)
> GM 90 505 789 D 12V
> LD031266 646
> This transmission ECU is from a 1998 Vectra 2.0L.
> I am trying to run this ECU on the bench and need to
> connect power and
> diagnostic lines to it.
> Thanks in advance.
> Best regards,
> Grant.

__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com

[Non-text portions of this message have been removed]

 
Received on Thu Dec 28 06:09:12 2006